Page 1 of 1
Drill / Pad Fit Warning
Posted: Thu Apr 06, 2023 12:34 pm
by -Tom-Tom-
- Pad Fit Warning.PNG (53.77 KiB) Viewed 6127 times
What does this Warning mean?
I have the problem more often, especially with designs with very few vias.
I attached the Gerber files and 3D.camset for analysis.
At ZofzPCB 2.0.0.6.
Same problem at ZofzPCB 2.0.1.0
Re: Drill / Pad Fit Warning
Posted: Thu May 04, 2023 11:03 pm
by Zofz
Many Gerber files and associated drill files have a different offset. For example, if you enable the 'center' function.
Therefore, the 'Auto-Offset' function is enabled by default (in Drill File Parameters - right-click on the drill plates window and select 'Setup Excellon Format'). You may switch the auto-offset off if your files are exported 'correctly'.
This popup is just a warning that the number of matching points (vs. all points) is not too high. But as I see, the holes are placed correctly, thanks to the two corner drills associated with pads.