Eagle & slotted pads ...
Posted: Fri Jul 08, 2022 4:40 pm
It's a silly topic... but Eagle doesn't/didn't support plated slotted holes.
Most PCB manufacturers support the workaround of drawing a milling line (milling diameter = line width) in the milling layer, wich will later become the plated slot.
By generating the Gerber file, the milling layer is exported to the dimension-gerber. Generating the slots in the drill file (*.xln) is not supported.
in Zofz: Wish & possible Eagle-Gerber-Export:
Most PCB manufacturers support the workaround of drawing a milling line (milling diameter = line width) in the milling layer, wich will later become the plated slot.
By generating the Gerber file, the milling layer is exported to the dimension-gerber. Generating the slots in the drill file (*.xln) is not supported.
in Zofz: Wish & possible Eagle-Gerber-Export: